Indiana BMV CDL General Knowledge Practice Test 3
Test 3 of 5. Pick an answer for each question to see if it is right and why; your score appears at the end. You need 40 correct answers to pass, the same ratio as the real Indiana test.
- Questions50
- Correct to pass40
- Passing score80%
- Minimum age18 years
-
1. You are stopped in a line of traffic behind a car. How much space should you leave in front of you?
Show answer
Answer C: Enough to see where the rear tires of that car meet the road
That amount of space lets you pull around the vehicle ahead if it stalls and absorbs some of the shock if you are struck from behind.
-
2. Rust streaks are running outward from the lug nuts on one wheel. What does this most likely indicate?
Show answer
Answer C: The lug nuts may be loose
Rust trails spreading from the nuts are a classic sign that the nuts have worked loose and the wheel has been moving on the studs.
-
3. How long must a motor carrier keep a driver vehicle inspection report and the certification of repairs?
Show answer
Answer B: Three months
The original report and the certifications attached to it are kept on file for three months from the date the report was prepared.
-
4. What must the motor carrier do about a defect listed on a driver vehicle inspection report?
Show answer
Answer D: Repair it, or certify that repair is not needed, before the vehicle is dispatched again
A reported defect must be corrected, or certified as not needing correction, and that certification is what the next driver reads before taking the vehicle.
-
5. Where are regrooved, recapped or retreaded tires not allowed on a truck or truck tractor?
Show answer
Answer C: On the front steering wheels
Regrooved and retreaded tires are prohibited on the front wheels of a truck or truck tractor because a steering tire blowout is extremely difficult to manage.
-
6. The temperature is around freezing and the road looks wet. What is a practical way to tell whether it is icy?
Show answer
Answer C: Check for ice building up on the mirrors, antenna or the front of the vehicle
Ice that forms on the mirror, antenna or windshield is a warning that the road surface is freezing too, and black ice can look like a wet road.
-
7. For an unblocked article longer than 10 feet, the minimum is two tiedowns plus how many more?
Show answer
Answer B: One more for every additional 10 feet of length or any part of 10 feet
Past the first 10 feet, one more tiedown is added for each additional 10 feet of length or any fraction of that distance.
-
8. What does the commercial driver manual tell you to do with the parking brake when you leave your vehicle?
Show answer
Answer B: Apply the parking brake every time you leave the vehicle
The manual is explicit that the parking brake goes on whenever the driver leaves the vehicle, because once nobody is at the controls it is the only thing holding it.
-
9. What is checked about the clutch and the gearshift during the in-cab inspection?
Show answer
Answer D: That the clutch free play is within the range the manufacturer specifies
Too little or too much clutch free play causes slipping or dragging, either of which can leave the driver unable to select the gear a hill demands.
-
10. How does the working load limit of a tiedown relate to the force that would break it?
Show answer
Answer B: The working load limit is a fraction of the breaking strength and is the figure you use
The working load limit is set well below the point at which the device would fail, and securement is always calculated from the working load limit, never from breaking strength.
-
11. The combined working load limit of the tiedowns on a load must equal at least what share of the cargo weight?
Show answer
Answer C: One half of the cargo weight
Federal securement rules set the aggregate working load limit at no less than half the weight of the article or group of articles being held.
-
12. What does gross vehicle weight mean, as opposed to gross vehicle weight rating?
Show answer
Answer B: The actual weight of the single vehicle plus everything it is carrying
Gross vehicle weight is what the vehicle actually weighs at that moment; the rating is the maximum the manufacturer allows it to weigh.
-
13. A 40 foot straight truck and a 70 foot tractor-trailer make the same right turn. Which needs more room and why?
Show answer
Answer B: The tractor-trailer, because the longer the vehicle the farther inside the rear wheels track
Off-tracking grows with the distance between the front and rear axles, so the longer combination cuts the corner much more sharply and needs extra room.
-
14. Before raising the hood to inspect the engine compartment, what should you do?
Show answer
Answer B: Shut off the engine, set the parking brake and chock the wheels if needed
The engine compartment is inspected with the engine off and the vehicle secured so nothing can move or turn while your hands are inside.
-
15. What must be true of the trailer landing gear before you move off?
Show answer
Answer B: Fully raised, with the crank handle secured and no missing or damaged parts
Landing gear left part way down can strike a railway crossing or a ramp, and a loose crank handle can swing out into a passing vehicle.
-
16. Which lights should be used in fog, by day or by night?
Show answer
Answer A: Low beams and fog lights, together with the four-way flashers
High beam light bounces back off the water droplets and makes seeing worse, while low beams, fog lights and flashers help you see and help others see you.
-
17. What does the suspension system weight rating tell the driver?
Show answer
Answer A: The maximum weight that the manufacturer says the suspension can carry
Like tires and axles, suspensions have a manufacturer capacity, and loading beyond it can damage springs and air bags.
-
18. The coolant temperature gauge climbs above its normal range on a long grade. What is the correct response?
Show answer
Answer C: Stop when it is safe to do so and find the cause before going on
Rising coolant temperature signals a fault such as a lost belt, a leak or a blocked radiator, and continuing can turn a repair into a destroyed engine.
-
19. Most rollovers of loaded trucks on exit and entrance ramps happen for which reason?
Show answer
Answer B: The ramp was taken faster than the load could tolerate
A posted ramp speed is set for cars, and a loaded trailer with a high center of gravity can roll at a speed a car would take easily.
-
20. Who must sign a driver vehicle inspection report?
Show answer
Answer D: The driver who prepared it
The report is the driver statement about the condition of the vehicle at the end of the day, so the driver signs it.
-
21. Why does a load need to be balanced from side to side?
Show answer
Answer B: Because a heavy side raises the rollover risk and can overload the tires and springs on that side
An uneven load tips the balance of the vehicle in curves and pushes the tires and suspension on the loaded side past their rating.
-
22. You are asked to drive a truck loaded with enough hazardous materials to require placards. What must you have?
Show answer
Answer C: A hazardous materials endorsement on your commercial driver license
Driving a vehicle that must be placarded requires the H endorsement, which involves a separate knowledge test and a security background check.
-
23. What does the tachometer on the dashboard of a heavy truck show?
Show answer
Answer D: How fast the engine is turning, in revolutions per minute
The tachometer reads engine speed in rpm, which is what a driver uses to judge shift points in a vehicle with a manual transmission.
-
24. On a wet road, a commercial driver should reduce speed by roughly how much?
Show answer
Answer C: By about one third
Cutting speed by roughly a third, for example from 55 to about 35 mph, restores a margin for the traction lost on a wet surface.
-
25. What blood alcohol concentration disqualifies a driver of a commercial motor vehicle in Indiana?
Show answer
Answer D: .04 percent or more
Indiana follows the federal standard: a driver may not operate a commercial motor vehicle with a blood alcohol concentration of .04 percent or more, half the .08 limit that applies to other vehicles.
-
26. What must be checked about the cargo doors and any tarpaulin before a trip?
Show answer
Answer B: That the doors are closed and latched and that any tarp is tied down securely
An unlatched door or a loose tarp can swing open or tear free at speed, spilling cargo or blocking the view of the traffic behind you.
-
27. What is the driver looking for when the exhaust system is inspected?
Show answer
Answer B: Loose, broken or missing pipes, brackets or clamps, and signs that exhaust is leaking
A loose or leaking exhaust system can send carbon monoxide into the cab and can put hot gas against parts that will burn.
-
28. Your vehicle is stopped just past a hill or curve that hides it from approaching traffic. How should the warning devices be adjusted?
Show answer
Answer A: Move the rearmost device farther back, up to 500 feet, so drivers are warned before the obstruction
When a hill or curve blocks the view, the farthest device is moved back beyond the obstruction so approaching drivers see the warning in time.
-
29. You find one lug nut missing from a wheel that has ten studs. What should you do?
Show answer
Answer C: Treat it as a defect and have it repaired before the vehicle is driven
Every missing fastener loads the others more heavily, and wheel separations usually begin with one nut that nobody replaced.
-
30. What is the danger of letting engine speed climb past the top of the rated rpm range before you shift?
Show answer
Answer B: You can damage the engine, so the shift should be made before that point
Every engine has a rated operating range; running above it can cause serious engine damage, so the upshift belongs at the top of that range, not beyond it.
-
31. An angry driver has cut in front of you and is now braking hard to provoke you. What is the safest response?
Show answer
Answer D: Drop back, avoid eye contact and let the driver go
Giving an aggressive driver space and no response removes the conflict, while any answering gesture invites escalation you cannot control in a heavy vehicle.
-
32. What does the gross vehicle weight rating of a vehicle describe?
Show answer
Answer A: The maximum loaded weight of that single vehicle, as specified by the manufacturer
The rating is the manufacturer figure for the loaded weight of one vehicle, so it is a limit fixed in advance rather than a measurement of the load on board today.
-
33. What should you do with the previous driver vehicle inspection report before starting your trip?
Show answer
Answer B: Review it and confirm that listed defects were certified as repaired or as not needing repair
Reviewing the last report and the carrier certification tells you whether reported defects have been corrected before you take the vehicle out.
-
34. On a multilane highway, which lane should a heavy vehicle normally use?
Show answer
Answer A: The right lane, except to pass or where signs direct otherwise
Keeping right leaves the faster lanes free and reduces the number of vehicles that have to move around a slower, heavier vehicle.
-
35. Which communication equipment is excluded from Indiana's definition of a telecommunications device?
Show answer
Answer A: Citizen band radio operated by an FCC-licensed operator and a communications system installed in a commercial vehicle over 10,000 pounds
Indiana's definition of a telecommunications device excludes citizen band radio equipment operated by an FCC-licensed CB operator and communications systems installed in commercial motor vehicles weighing more than 10,000 pounds.
-
36. Why is backing toward the driver side preferred?
Show answer
Answer C: You can watch the rear of the vehicle directly through the side window
Backing to the left lets the driver look out the window and see the rear of the vehicle directly instead of relying on a mirror alone.
-
37. Within total stopping distance, what exactly is perception distance?
Show answer
Answer D: The distance traveled from the moment your eyes see a hazard until your brain identifies it
Perception distance covers only the time between seeing a hazard and recognizing it as a hazard, before any physical reaction begins.
-
38. How is free play in the steering wheel measured during the inspection?
Show answer
Answer B: By turning the wheel until the front wheels just start to move and noting the movement
Play is the movement at the rim that produces no movement at the road wheels, so it is measured by turning until the wheels first respond.
-
39. When should a driver select the gear for a long, steep downgrade?
Show answer
Answer B: Before starting down the grade
The low gear has to be chosen before the descent, because a heavy vehicle gaining speed may refuse to shift down at all.
-
40. What is the purpose of the torque rods or radius rods you check on the suspension?
Show answer
Answer A: They hold the axle in alignment with the frame under braking and acceleration
Torque rods resist the twisting and fore and aft forces on the axle, so a cracked or missing rod lets the axle move out of alignment.
-
41. After the first inspection of a trip, how often must cargo securement be checked again?
Show answer
Answer D: Every 3 hours or 150 miles or at each change of duty status, whichever happens first
The load must be re-checked at whichever of those points arrives first, so a loosening tiedown is found long before it fails.
-
42. What is the correct way to make a normal stop?
Show answer
Answer A: Push the brake pedal down gradually and bring the vehicle to a smooth stop
Steady, progressive pedal pressure keeps the vehicle stable and lets the driver behind you react to a predictable slowdown.
-
43. How should speed and gears be handled when approaching a curve?
Show answer
Answer A: Slow to a safe speed and downshift before entering the curve
Braking and shifting are completed before the curve so the vehicle is settled and can pull gently through it without upsetting the load.
-
44. Why must cargo also be held down against vertical movement and not only against sliding?
Show answer
Answer D: Because a load that bounces can jump the blocking and slacken its own tiedowns
Rough road makes an unrestrained article lift; every bounce lets it move a little and works the tiedowns loose until nothing is holding it.
-
45. Where should a trailer be dropped, and what else does the driver do before pulling out from under it?
Show answer
Answer C: On solid level ground, with the trailer wheels chocked if it may roll
A dropped trailer must sit on ground that will carry the landing gear without sinking, and chocks stop it rolling once the tractor and its air supply are gone.
-
46. You are backing with a helper guiding you and the helper drops out of sight in your mirror. What should you do?
Show answer
Answer B: Stop until you can see the helper again
If you cannot see the helper you cannot receive a signal to stop, so the only safe action is to halt until visual contact is restored.
-
47. While double clutching, what goes wrong if you take too long between the two clutch movements?
Show answer
Answer A: Engine speed falls too far and the gear becomes hard or impossible to engage
Double clutching only works while engine speed and road speed still match; a slow shift lets rpm drop away and the gear will not go in.
-
48. How do you get more engine braking from an automatic transmission on a downgrade?
Show answer
Answer B: Select a lower range before starting down
Locking the transmission into a lower range keeps engine speed high enough to hold the vehicle back and spares the service brakes.
-
49. Why is it harder to judge speed and distance at night?
Show answer
Answer C: You see much less detail and have fewer reference points
Darkness removes the visual references that the brain uses to estimate distance and closing speed, so drivers routinely misjudge both.
-
50. Your drive wheels start to spin and the rear begins to slide while you accelerate on a slick surface. What should you do?
Show answer
Answer B: Stop accelerating and, if the vehicle has a manual transmission, push in the clutch
An acceleration skid ends when the drive wheels stop pushing, so easing off the throttle and disengaging the clutch lets them regain grip.