Indiana BMV CDL General Knowledge Practice Test 10
- Questions50
- Correct to pass40
- Passing score80%
- Minimum age18 years
-
1. What is the first step of the standard seven-step vehicle inspection?
Show answer
Answer C: A general overview of the vehicle, including the last inspection report
The routine opens with a walk-up overview of the vehicle and a review of the previous inspection report so known defects are addressed first.
-
2. Cargo falls from your trailer and causes a crash behind you. Who is likely to answer for it?
Show answer
Answer C: The driver and the carrier, since securing the load on the road is their duty
Whoever loaded the vehicle, the driver and the carrier are responsible for the load being secure while it is on the road.
-
3. What are you looking for on the brake drums during the walkaround?
Show answer
Answer B: Cracks, dents and any oil or grease that has reached the friction surface
A cracked or badly scored drum can break apart under braking heat, and oil or grease on the friction surface destroys the braking effort at that wheel.
-
4. You are dropping a loaded trailer in a yard. How far should the landing gear be lowered?
Show answer
Answer A: Until the pads make firm contact and the trailer weight is just off the fifth wheel
Cranking down until the gear is firmly on the ground and just lifting the load off the fifth wheel makes the trailer stable and lets the tractor pull out cleanly.
-
5. Why does the commercial driver manual tell you to look far down the road instead of only at the vehicle ahead?
Show answer
Answer D: So you can adjust smoothly instead of braking hard at the last moment
A heavy vehicle cannot react quickly, so early information lets you slow gradually rather than make a sudden stop or swerve.
-
6. Your windshield washer reservoir is empty and rain and road spray are expected. What should you do?
Show answer
Answer D: Fill it before the trip, because you need the washers to keep the windshield clear
Wipers alone smear the film of oil and grit thrown up by traffic, so the washers are part of keeping a usable view of the road.
-
7. A dock crew loads all of the freight at the very back of a 48 foot van trailer. What are the two consequences?
Show answer
Answer A: The steering axle is relieved of weight and steering becomes light, and the trailer axles may go over the limit
Weight placed far to the rear lifts weight off the front of the combination, so the steering goes light while the trailer axles take too much of the load.
-
8. Apart from the risk of stalling, why is rolling backwards when starting on an upgrade so serious in a heavy vehicle?
Show answer
Answer D: You can strike the vehicle behind you, which is often much closer than you think
You cannot see how close the vehicle behind has stopped, and even a short roll back is enough to hit it.
-
9. Which items belong to the in-cab part of the inspection?
Show answer
Answer D: Gauges, controls, mirrors, windshield, wipers, horn, heater and defroster
The in-cab step checks the instruments and controls the driver depends on, along with mirrors, glass, wipers, horn and the heater and defroster.
-
10. What does the working load limit stamped on a chain or strap describe?
Show answer
Answer B: The maximum load the device is rated to hold in normal use
The working load limit is the rated safe capacity for everyday use, deliberately set well below the force that would break the device.
-
11. What do the U-bolts on a leaf spring suspension do?
Show answer
Answer A: They clamp the spring assembly to the axle so it cannot move
U-bolts hold the spring pack tight against the axle, and a loose or broken U-bolt lets the axle slide out of place under load.
-
12. You are strapping down a load with sharp metal edges on a flatbed. What should you use?
Show answer
Answer D: Edge protection between the strap and the sharp edges so the tiedown is not cut
Sharp edges cut or wear through a strap under tension, so edge protectors are required wherever a tiedown could be damaged.
-
13. Why should a large vehicle be accelerated smoothly and gradually?
Show answer
Answer A: Rough acceleration can damage the drivetrain and, on a combination, the coupling
Jerky throttle inputs put shock loads through the driveline and the coupling, which causes mechanical damage over time.
-
14. A company mechanic serviced your truck this morning and signed the work order. Do you still have to inspect the vehicle?
Show answer
Answer B: Yes, the driver is still responsible for being satisfied the vehicle is safe
Shop work does not transfer the duty; the driver who takes the vehicle out remains responsible for being satisfied it is in safe operating condition.
-
15. An unblocked article is 8 feet long and weighs 900 pounds. How many tiedowns does the federal rule require?
Show answer
Answer B: Two
Only an article that is 5 feet or shorter and 1,100 pounds or lighter can be held with a single tiedown; anything longer than 5 feet needs at least two whatever it weighs.
-
16. During the walkaround you notice one tire on an axle is a radial and the tire next to it is bias-ply. What should you do?
Show answer
Answer B: Treat it as a defect, because radial and bias-ply tires must not be mixed on the same axle
Radial and bias-ply tires flex and grip differently, so mixing them on one axle makes the vehicle handle unpredictably and is not allowed.
-
17. You are told a posted bridge ahead has a weight limit lower than your gross weight. What must you do?
Show answer
Answer C: Take a route that avoids it, because a posted limit is a legal limit
A posted structure limit must be obeyed exactly as any other weight limit, so a heavier vehicle has to be routed around it.
-
18. Federal rules keep recapped and retreaded tires off the front wheels of which vehicle?
Show answer
Answer B: Any bus carrying passengers
The federal rule names buses: a bus may not run with regrooved, recapped or retreaded tires on its front wheels, because a steer tire failure with passengers aboard takes away steering control.
-
19. How does bracing differ from blocking when securing cargo?
Show answer
Answer B: Bracing runs from the upper part of the cargo to the floor or walls to keep it from moving, while blocking fits snugly against the cargo
Blocking is shaped to fit against the front, back or sides of a piece of cargo; bracing supports it from above so it cannot tip or shift.
-
20. When should a lower gear be selected for a long downgrade?
Show answer
Answer D: Before you start down the hill
The gear is chosen at the top, while speed is still low, because a heavy vehicle already rolling fast may not go into a lower gear at all.
-
21. Which vehicle condition makes hydroplaning more likely?
Show answer
Answer C: Tires that are worn or underinflated
Tread depth and correct pressure are what let a tire push water aside, so worn or soft tires lift onto the water film at lower speeds.
-
22. Why must exhaust components be checked for contact with other parts of the vehicle?
Show answer
Answer B: Hot exhaust parts touching fuel lines, tires or wiring can start a fire
Exhaust pipes run hot enough to ignite fuel and melt insulation, so they must be kept clear of the fuel system, the tires and the electrical harness.
-
23. Why should you avoid using your lights to tell a following driver that it is safe to pass you?
Show answer
Answer B: You may misjudge the gap and the driver will act on your signal
The manual warns against signaling others to pass, because the responsibility for a head-on crash then rests on a judgment you could easily get wrong.
-
24. How do you get more engine braking from an automatic transmission on a downgrade?
Show answer
Answer B: Select a lower range before starting down
Locking the transmission into a lower range keeps engine speed high enough to hold the vehicle back and spares the service brakes.
-
25. What blood alcohol concentration disqualifies a driver of a commercial motor vehicle in Indiana?
Show answer
Answer D: .04 percent or more
Indiana follows the federal standard: a driver may not operate a commercial motor vehicle with a blood alcohol concentration of .04 percent or more, half the .08 limit that applies to other vehicles.
-
26. How does overloading affect the way a vehicle drives?
Show answer
Answer C: It slows the vehicle on upgrades, makes stopping take longer and can overheat the brakes on downgrades
Extra weight demands more from the engine and the brakes, so the vehicle climbs slowly and needs much more distance to stop.
-
27. What are you checking when you pull the engine oil dipstick during the pre-trip?
Show answer
Answer A: That the oil level is within the safe operating range marked on the stick
The dipstick shows whether there is enough oil to lubricate and cool the engine, and a level outside the safe range must be corrected before driving.
-
28. In hazard perception, what counts as a hazard?
Show answer
Answer C: Any road user or condition that could become a danger
A hazard is anything with the potential to create danger, which is why drivers are taught to spot them early rather than react to emergencies.
-
29. When is a road surface usually most slippery during a rain shower?
Show answer
Answer A: Just after the rain starts, when water mixes with oil and dirt on the surface
The first rain lifts oil and dust into a slick film that has not yet been washed away, so the road is more slippery than it will be later.
-
30. You hear air escaping from a trailer tire during the pre-trip. What should you do?
Show answer
Answer C: Have it repaired or replaced before the vehicle is driven
An audible leak means the tire is failing now, and federal rules do not allow a vehicle to be operated on a flat or leaking tire.
-
31. What condition should the fifth wheel be in before you back under a trailer?
Show answer
Answer C: Jaws open, plate greased, and the fifth wheel tilted down toward the rear
The jaws have to be open to take the kingpin, the plate must be lubricated to prevent hard steering, and the fifth wheel is tilted down at the rear so the trailer apron can ride up onto it.
-
32. How long is an Indiana commercial driver's license valid?
Show answer
Answer C: Four years
An Indiana CDL is valid for four years, while a standard driver's license is valid for six years for a driver under 75.
-
33. What should be checked about the power steering system in the engine compartment?
Show answer
Answer D: That the fluid level is correct and the hoses and pump are not leaking
Losing power steering fluid means losing steering assistance, which can happen suddenly and makes a heavy vehicle very hard to turn.
-
34. What is the danger of letting engine speed climb past the top of the rated rpm range before you shift?
Show answer
Answer B: You can damage the engine, so the shift should be made before that point
Every engine has a rated operating range; running above it can cause serious engine damage, so the upshift belongs at the top of that range, not beyond it.
-
35. Why should a retarder be switched off when the road is wet, icy or snowy?
Show answer
Answer C: It can make the drive wheels skid when traction is poor
A retarder slows the drive wheels only, and on a slippery surface that braking force can break their traction and start a skid.
-
36. What does the suspension system weight rating tell the driver?
Show answer
Answer A: The maximum weight that the manufacturer says the suspension can carry
Like tires and axles, suspensions have a manufacturer capacity, and loading beyond it can damage springs and air bags.
-
37. Which clues warn you that a parked car may pull out or open a door?
Show answer
Answer A: Exhaust smoke, turned front wheels, a person in the seat
Signs of life in a parked vehicle, such as a running engine, turned wheels or an occupant, mean it may move or open a door into your path.
-
38. An oncoming vehicle drifts across the center line into your lane. What is usually the safest move?
Show answer
Answer C: Steer to the right, toward the shoulder if necessary
Moving right keeps you away from the drifting vehicle and off the oncoming side; the other driver may swerve back and hit you if you go left.
-
39. What makes a brake hose or air line a defect during the walkaround?
Show answer
Answer D: It is cracked, worn, kinked, or rubbing against another part
A chafed or cracked line can burst under pressure and take the braking on that circuit with it, so damage and rubbing points must be corrected.
-
40. Rust streaks are running outward from the lug nuts on one wheel. What does this most likely indicate?
Show answer
Answer C: The lug nuts may be loose
Rust trails spreading from the nuts are a classic sign that the nuts have worked loose and the wheel has been moving on the studs.
-
41. Which steering system findings count as defects during the inspection?
Show answer
Answer C: Bent, loose or broken column parts, arms, drag links or tie rods, and missing nuts, bolts or cotter keys
Every joint and fastener between the steering wheel and the tires carries the driver commands, so looseness or a missing retainer can end in a complete loss of steering.
-
42. The only way into a customer yard forces you to back toward the right, or blind, side of the vehicle. What should you do?
Show answer
Answer D: Use a helper and get out to check the path more often than you normally would
Blind side backing is allowed but far riskier, so it calls for a spotter you can see and for repeated checks of the path on foot.
-
43. An unblocked article is 15 feet long. What is the minimum number of tiedowns?
Show answer
Answer B: Three
Two tiedowns cover the first 10 feet and one more is added for each further 10 feet or any part of it, so 15 feet needs three.
-
44. Why should a long vehicle never swing out to the left before starting a right turn?
Show answer
Answer D: Another driver may read it as a left turn or pass on your right
Swinging left opens a gap on your right that a car will move into, and it also sends a false message about which way you are going.
-
45. Which of these is a major cause of skids in heavy vehicles?
Show answer
Answer C: Over-braking, over-steering, over-acceleration or driving too fast for conditions
Skids happen when the tires are asked for more grip than the road can give, which happens through braking, steering or accelerating too hard or simply too much speed.
-
46. The car in the next lane still has snow covering most of its windows. What should you assume?
Show answer
Answer C: That driver cannot see you and may move into your lane
A driver whose view is blocked cannot see the vehicles around, so you should assume you are invisible and stay out of that vehicle path.
-
47. What does it mean to overdrive your headlights at night?
Show answer
Answer D: Driving so fast that you cannot stop within the distance lit by your headlights
You must be able to stop inside the distance you can see; at night that distance is limited by the headlights, so speed must be lowered to match.
-
48. Before raising the hood to inspect the engine compartment, what should you do?
Show answer
Answer B: Shut off the engine, set the parking brake and chock the wheels if needed
The engine compartment is inspected with the engine off and the vehicle secured so nothing can move or turn while your hands are inside.
-
49. An oncoming vehicle at night has bright headlights that are making it hard to see. What should you do?
Show answer
Answer B: Look toward the right edge of your lane and avoid looking directly at the lights
Looking at the right edge of the road keeps your eyes off the glare while you stay in your lane; glare can leave you nearly blind for several seconds.
-
50. An article of cargo has been blocked so that it cannot move forward. How many tiedowns does the federal rule call for?
Show answer
Answer A: One tiedown for every 10 feet of article length, or any part of that
Blocking against forward movement lowers the requirement to one tiedown per 10 feet of length or fraction of 10 feet.