Indiana BMV CDL General Knowledge Practice Test 1
Test 1 of 5. Pick an answer for each question to see if it is right and why; your score appears at the end. You need 40 correct answers to pass, the same ratio as the real Indiana test.
- Questions50
- Correct to pass40
- Passing score80%
- Minimum age18 years
-
1. Regular mirror checks during a long trip can reveal which developing problem?
Show answer
Answer D: Smoke coming from a tire or from a wheel
Overheating tires, wheel bearings and brakes usually show as smoke long before anything appears on the dash, and mirrors are where a driver sees it.
-
2. During the vehicle overview, what should the driver look for on the ground under the vehicle?
Show answer
Answer B: Fresh puddles of oil, coolant, grease or fuel
New stains on the ground are the earliest sign of a leak, so the overview includes a look underneath before anything is opened or started.
-
3. What should you check about the air hoses and the electrical cord running to the trailer?
Show answer
Answer D: That they are free of damage, properly connected and not dragging or rubbing
Lines that chafe on the frame or drag on the road wear through, and a broken line takes away trailer braking or trailer lighting without warning.
-
4. What are you checking on the mud flaps during the walkaround?
Show answer
Answer C: That they are securely attached, not torn and not dragging on the ground
A flap that is torn or hanging loose stops shielding following traffic from spray and stones, and a dragging flap can catch and tear away on the road.
-
5. Your vehicle begins to hydroplane on a wet road. What should you do?
Show answer
Answer B: Release the accelerator and push in the clutch so the wheels can turn freely and regain grip
Hydroplaning tires are riding on water; slowing without braking lets them settle back onto the road and grip again.
-
6. Which of these counts as a serious traffic violation for a commercial driver license holder?
Show answer
Answer C: Speeding 15 miles per hour or more above the limit
Excessive speeding, reckless driving, improper lane changes, following too closely and texting while driving are all serious traffic violations.
-
7. What is the risk when too little weight rests on the drive axles?
Show answer
Answer A: Poor traction, so the drive wheels spin easily on wet or slippery surfaces
Traction depends on weight pressing the driving tires onto the road, so a light drive axle spins on wet, snowy or loose surfaces.
-
8. A commercial vehicle stops on the shoulder of an undivided two-lane road that carries traffic in both directions. Where do the warning devices go?
Show answer
Answer B: Within 10 feet of the vehicle, plus 100 feet to the front and 100 feet to the rear
On a two-way road the devices must mark the vehicle itself and warn traffic approaching from each direction, and they must be in place within ten minutes.
-
9. You are pulling a loaded pneumatic dry bulk trailer and approach an exit ramp posted at 35 mph. What is the safest approach?
Show answer
Answer C: Slow to well below the posted speed before the ramp begins
A dry bulk trailer carries its weight high and the load can move, so the ramp speed posted for a car is far too fast and the slowing must be finished before the curve.
-
10. Besides being uncomfortable, what can a series of hard, jerky brake applications do to a loaded combination?
Show answer
Answer A: Shift the load and push the trailer out of line behind the tractor
Sudden, uneven braking can move cargo forward and upset the alignment of a trailer, which is why stops should be made smoothly.
-
11. What is the minimum tread depth for tires in positions other than the steering axle?
Show answer
Answer A: 2/32 inch
Drive and trailer tires must keep at least 2/32 inch of tread in a major groove, measured away from tie bars and fillets.
-
12. What must be checked on a sliding fifth wheel during the inspection?
Show answer
Answer B: That it is locked in position and not so far forward that the trailer can hit the cab
A slider that is unlocked can move under braking, and one set too far forward lets the trailer strike the cab when the tractor turns sharply.
-
13. How long is an Indiana commercial driver's license valid?
Show answer
Answer C: Four years
An Indiana CDL is valid for four years, while a standard driver's license is valid for six years for a driver under 75.
-
14. A chain rated at 6,600 pounds is fitted with a hook rated at 4,700 pounds. What is the working load limit of that assembly?
Show answer
Answer A: 4,700 pounds, the rating of the weakest part
An assembly is only as strong as its weakest component, so hooks, binders and links all count and the lowest rating governs.
-
15. Federal rules forbid operating a commercial vehicle in which condition?
Show answer
Answer C: In a condition likely to cause a crash or a breakdown
A defect that makes a crash or a breakdown likely has to be corrected before the vehicle is driven, not reported at the end of the trip.
-
16. How soon must warning devices be placed after a commercial vehicle stops on the traveled part or the shoulder of a highway?
Show answer
Answer D: As soon as possible and in any case within 10 minutes
The hazard warning flashers go on immediately and the warning devices must be in place as soon as possible, never later than 10 minutes after stopping.
-
17. You are loading lengths of large diameter pipe on a flatbed. What is needed besides the tiedowns?
Show answer
Answer D: Chocks, wedges or cradles that keep the pipe from rolling
Anything that can roll must be prevented from rolling by chocks, wedges, cradles or a similar device that is itself secured so it cannot come out.
-
18. Why does a load of hanging meat in a refrigerated trailer require special care in curves?
Show answer
Answer D: The meat swings and has a high center of gravity, which makes the trailer unstable
Hanging meat is heavy, sits high and swings, so the trailer can tip in a curve or on a ramp taken at normal speed.
-
19. During the walkaround inspection, where does the driver normally start and how does the check proceed?
Show answer
Answer C: At the left front of the vehicle, working around it in a set order that returns to the cab
The walkaround follows the same route every time, starting at the left front and circling the vehicle, so that nothing is skipped when the driver is tired or rushed.
-
20. How should the steering wheel be held when driving a large vehicle?
Show answer
Answer D: Firmly with both hands, placed on opposite sides of the wheel
Both hands on opposite sides give the leverage and control needed if a tire drops off the pavement or the wheel is jolted.
-
21. What is the correct order for a double clutch downshift?
Show answer
Answer D: Release the accelerator and push the clutch to reach neutral, release the clutch and press the accelerator to raise engine speed, then push the clutch again and select the lower gear
A lower gear turns faster than the one being left, so engine speed has to be raised in neutral before that gear will engage cleanly.
-
22. You are taking a tightly curved highway exit ramp in a long combination. Where should the tractor be placed within the lane?
Show answer
Answer D: Toward the outside of the curve, leaving room for the trailer to track inside
Because the trailer wheels cut to the inside of the curve, the tractor has to be kept out toward the outer edge so the trailer does not drop a wheel off the inside edge.
-
23. Under federal rules, which commercial vehicles must stop at every railroad crossing before proceeding?
Show answer
Answer D: Passenger buses and placarded hazardous materials vehicles
Buses carrying passengers and vehicles required to display hazardous materials placards must stop at crossings, while other commercial vehicles slow and check.
-
24. You are pulling away from the curb after a delivery. Why is a mirror check needed first?
Show answer
Answer B: A cyclist or a vehicle may be coming up alongside you
Traffic and cyclists can arrive alongside a parked vehicle at any moment, so the mirrors must be checked immediately before pulling out.
-
25. What must a written driver vehicle inspection report cover at the end of the day?
Show answer
Answer C: Any defect or deficiency that would affect safety or could cause a mechanical breakdown
The report identifies the vehicle and lists defects that affect safe operation or could lead to a breakdown, so they are repaired before the next trip.
-
26. An empty van trailer cleared a low overpass on the way in, but on the way back it is loaded. Which statement is true?
Show answer
Answer C: An empty van rides higher than a loaded one, so it needs more clearance than when loaded
Springs compress under load, so an empty trailer is taller; the unloaded trip is the one that can catch a low overhead.
-
27. What should you do before backing into a space you have not used before?
Show answer
Answer A: Get out and walk around to check the path, the clearance and any obstacles
Walking the area first reveals low obstructions, soft ground and objects that never appear in the mirrors.
-
28. Under the federal air brake standard, the low air pressure warning must come on before reservoir pressure drops below what level?
Show answer
Answer A: Before pressure falls below 60 psi
Federal Motor Vehicle Safety Standard 121 requires the warning to operate while service reservoir pressure is still above 60 psi, which leaves enough air to bring the vehicle to a normal stop.
-
29. A tire blows out at highway speed. What should the driver do first?
Show answer
Answer C: Hold the steering wheel firmly, stay off the brake and let the vehicle slow down
Braking while a tire is gone can pull the vehicle out of line, so the driver keeps it straight and lets speed fall before easing off the road.
-
30. What limitations apply to an Indiana CDL holder who is under 21?
Show answer
Answer B: They may operate a commercial motor vehicle for intrastate commerce only and may not apply for the school bus endorsement
Indiana restricts CDL holders under 21 to intrastate commerce and makes them ineligible for the school bus endorsement, which requires age 21.
-
31. Which exhaust system condition must be reported as a defect?
Show answer
Answer B: A section repaired by wrapping tape or patching material around the pipe
Exhaust parts may not be patched with wrap or tape, because the repair does not contain the gas or the heat and it fails quickly in service.
-
32. Why does a cracked frame rail or cross member make a vehicle unsafe?
Show answer
Answer B: The frame carries the whole load, and a crack can spread until the structure fails
The frame is the backbone that supports the body, the load and the running gear, so a crack in it is a structural failure that grows with every mile.
-
33. The car in the next lane still has snow covering most of its windows. What should you assume?
Show answer
Answer C: That driver cannot see you and may move into your lane
A driver whose view is blocked cannot see the vehicles around, so you should assume you are invisible and stay out of that vehicle path.
-
34. You normally pull an empty trailer, but today the same tractor is loaded to its legal maximum. What changes about getting under way?
Show answer
Answer A: You may need to start in a lower gear, since the load takes more pulling power
The heavier the load, the lower the gear needed to get the vehicle rolling without lugging or stalling the engine.
-
35. What happens when too much of the load sits over the steering axle?
Show answer
Answer D: The vehicle becomes hard to steer and the axle and its tires can be damaged
Weight beyond the front axle rating makes the steering heavy and can overload the axle and the tires carrying it.
-
36. During the walkaround you notice a bulge in the sidewall of a trailer tire. What does it indicate?
Show answer
Answer B: Damage inside the tire, which can lead to a sudden failure
A bulge means the internal structure has broken and only the rubber is holding the air, so the tire can burst without warning.
-
37. When should mirror adjustment be checked, and what should each mirror show?
Show answer
Answer B: Before every trip, with each mirror adjusted to show some part of the vehicle
Checking the mirrors before each trip and keeping a small part of the vehicle in view gives a reference point for judging distance behind and beside you.
-
38. Which items belong to the in-cab part of the inspection?
Show answer
Answer D: Gauges, controls, mirrors, windshield, wipers, horn, heater and defroster
The in-cab step checks the instruments and controls the driver depends on, along with mirrors, glass, wipers, horn and the heater and defroster.
-
39. What are you checking when you look at the batteries during the engine compartment inspection?
Show answer
Answer D: That they are securely mounted, the connections are tight and free of corrosion, and the caps are in place
Loose or corroded batteries can fail or short out, so the mount, cables, terminals and vent caps are all part of the check.
-
40. What is the first step of the standard seven-step vehicle inspection?
Show answer
Answer C: A general overview of the vehicle, including the last inspection report
The routine opens with a walk-up overview of the vehicle and a review of the previous inspection report so known defects are addressed first.
-
41. What frame defects are you looking for during the walkaround?
Show answer
Answer A: Cracks, bends or broken cross members
The frame carries the whole load, so cracked or bent rails and broken cross members are serious structural defects.
-
42. A driver snores heavily, stops breathing briefly during the night and is tired all day despite long hours in bed. What should be suspected?
Show answer
Answer B: Sleep apnea
Sleep apnea repeatedly interrupts breathing during sleep, so the driver never gets true rest and stays dangerously drowsy during the day.
-
43. What is the driver responsible for when a load is covered with a tarp?
Show answer
Answer C: Fastening it so it cannot flap free, block a mirror, or come off in the wind
A tarp that works loose can tear away, block the driver view or the view of others, and become a hazard for the traffic behind.
-
44. What should the ammeter or voltmeter show once the engine is running?
Show answer
Answer D: A reading in the normal charging range
With the engine running, the alternator should be charging; a discharge reading or an abnormal charge level means an electrical fault.
-
45. Which description matches controlled braking during an emergency stop?
Show answer
Answer D: Apply the brakes as hard as you can without locking the wheels and keep steering movements small
Controlled braking keeps the wheels rolling just short of lockup, which gives the shortest stop while you keep the ability to steer.
-
46. In dense city traffic you cannot see 12 seconds ahead because other vehicles block the view. What is the best response?
Show answer
Answer A: Slow down and open up more space in front of you
When you cannot see far enough ahead, extra following distance buys back the reaction time that the blocked view has taken away.
-
47. Why should a driver avoid stopping partway up a snow covered hill?
Show answer
Answer D: You may not get moving again and could slide backwards
On a slippery grade the drive wheels may simply spin when you try to restart, leaving the vehicle stuck across the road or sliding back down it.
-
48. You are backing into a yard where electrical wires cross overhead. What is the main concern?
Show answer
Answer C: The wires may hang lower than the top of your vehicle
Overhead space has to be checked like any other space around the vehicle, because wires and cables are often lower than they look from the cab.
-
49. Federal rules require a power unit that is not carrying placarded hazardous materials to have a fire extinguisher with which minimum rating?
Show answer
Answer A: One rated 5 B:C or more, or two rated 4 B:C or more each
The minimum is a single unit rated 5 B:C or more, or two units of at least 4 B:C each, which is enough to attack a fuel or electrical fire.
-
50. What makes a brake hose or air line a defect during the walkaround?
Show answer
Answer D: It is cracked, worn, kinked, or rubbing against another part
A chafed or cracked line can burst under pressure and take the braking on that circuit with it, so damage and rubbing points must be corrected.