Indiana BMV Motorcycle Practice Test 37

  • Questions25
  • Correct to pass20
  • Passing score80%
  • Minimum age16 years and 90 days

Minimum age: 16 years and 90 days for a motorcycle endorsement; a valid Indiana driver's license is required for a motorcycle learner's permit

25 questions. Pick an answer to see if it is right and why; you need 20 correct answers to pass.

  1. 1. A sign reads REDUCED SPEED LIMIT AHEAD. What does it tell you?

    Show answer

    Answer D: A lower limit begins further along the road

    The sign gives advance notice so a driver can slow gradually, and the new figure takes effect at the speed limit sign that follows.

  2. 2. When should a passenger get on the motorcycle?

    Show answer

    Answer D: After the engine has been started and the operator is ready

    Mounting after the engine is running and the operator is settled keeps the motorcycle stable and spares the operator a long balancing act with the extra weight aboard.

  3. 3. What counts as a complete stop at a stop sign?

    Show answer

    Answer C: The wheels stop turning before the stop line

    A legal stop means the vehicle is no longer moving, made at the stop line or before entering the crosswalk or intersection.

  4. 4. In a work zone, the flagger's instructions conflict with the pavement markings still visible on the road. Which do you follow?

    Show answer

    Answer B: The flagger, because a person directing traffic outranks the markings

    An authorized flagger controlling a temporary traffic control zone overrides signs, signals and markings, and drivers must obey the flagger's signals.

  5. 5. You are circulating in the inner lane of a two-lane roundabout, your exit is next, and a vehicle is beside you in the outer lane. What should you do?

    Show answer

    Answer C: Keep circulating around the island and take that same exit on your next time around

    You may not cut across a vehicle in the outer lane; if you cannot exit safely, continue around the circle and try again.

  6. 6. After completing a turn you notice your signal is still flashing. What should you do?

    Show answer

    Answer A: Switch it off at once, before other drivers act on it

    A signal left on after a turn is a false message, and drivers waiting to pull out may move into your path because of it.

  7. 7. How should a helmet sit on the head once it is fastened?

    Show answer

    Answer C: Level on the head, with the eye port giving a clear view of the road

    A helmet worn level protects the forehead and gives full vision, while one pushed back leaves the forehead exposed in a crash.

  8. 8. Is a helmet worth wearing on a short trip to a store a few blocks away?

    Show answer

    Answer C: Yes, since many crashes happen close to home at ordinary street speeds

    A large share of motorcycle crashes occur on short, familiar trips at moderate speeds, and injuries at those speeds are still severe.

  9. 9. You are pulling out of a farm entrance onto a rural highway. What is your obligation?

    Show answer

    Answer C: Yield to every vehicle already on the highway before you enter the roadway

    A driver entering a highway from a private road or driveway yields to every vehicle already on the highway.

  10. 10. Why do experienced riders squeeze the clutch lever while starting the engine, even with the neutral light showing?

    Show answer

    Answer A: In case a gear is engaged, so the motorcycle cannot lurch forward

    A neutral light can be wrong, and a disengaged clutch means the machine stays still even if the transmission is actually in gear.

  11. 11. While you swerve around an obstacle, what should the rest of your body be doing?

    Show answer

    Answer C: Staying upright with the knees against the tank while the motorcycle leans

    A swerve happens through the handlebars, and a body that stays still and anchored to the tank lets the motorcycle move quickly beneath the rider.

  12. 12. You have just passed a large truck on the freeway. Why is it dangerous to pull back in front of it and then brake for your exit?

    Show answer

    Answer B: A loaded truck needs much more distance to stop than a car

    A fully loaded tractor-trailer can need the length of a football field or more to stop from highway speed. Cutting in and braking leaves the driver no room to avoid hitting you.

  13. 13. An overhead sign shows that the right lane is EXIT ONLY. What does that mean if you intend to stay on the highway?

    Show answer

    Answer B: You have to move out of that lane before the exit

    An exit only lane leaves the highway completely, so a driver continuing on the highway has to change lanes before it does.

  14. 14. What must a motorcycle be equipped with before it can safely carry a passenger?

    Show answer

    Answer B: A seat large enough for two people and a set of passenger footrests

    A passenger needs a seat with room for both people without crowding and firm footrests to brace against.

  15. 15. A line beside your lane is painted about twice the normal width. What does the extra width convey?

    Show answer

    Answer B: Greater emphasis on the restriction it carries

    Width is part of the marking code: a wide line carries more emphasis than a normal one, which is why it is used at gores and channelizing lines.

  16. 16. Where does loose sand and gravel most often collect on a paved road?

    Show answer

    Answer D: Along the edges of the road and on curves and highway ramps

    Traffic sweeps loose material toward the outside of the travel path, so it builds up at the road edges and on curves and on entrance and exit ramps.

  17. 17. The divided highway ends warning sign means that

    Show answer

    Answer D: the median separating the directions ends and the road returns to two-way operation

    Beyond this sign opposing traffic is no longer separated by a median, so the driver must keep right and expect vehicles approaching in the adjacent lane.

  18. 18. A raised area crosses the roadway and carries a series of white markings on its face. What are those markings for?

    Show answer

    Answer A: To make the hump visible so drivers slow for it

    Speed hump markings warn drivers that the pavement rises, which matters most at night or when the hump is in shadow.

  19. 19. You enter a work zone where the top layer of pavement has been milled off, leaving a grooved surface. How should you ride?

    Show answer

    Answer B: Hold a relaxed grip and steady speed, and expect the tires to wander

    Milled or grooved pavement makes the tires follow the ridges and the motorcycle feel unsettled, so relax on the bars, keep a constant speed and ride straight through.

  20. 20. Your group arrives at a stop sign at a busy crossroad. How should each rider treat it?

    Show answer

    Answer C: Stop and pull out only when there is an adequate gap of your own

    Following the machine ahead through a junction without looking is a common cause of group crashes, because the gap the leader used has already closed.

  21. 21. You are about to leave a roundabout when a pedestrian steps into the crosswalk on your exit. What should you do?

    Show answer

    Answer B: Yield to the pedestrian and wait for the crosswalk to clear

    Roundabout crosswalks sit on the entries and exits, and drivers must yield to pedestrians using them.

  22. 22. What should a passenger do when the motorcycle leans into a curve?

    Show answer

    Answer A: Lean with the operator, staying directly behind them

    A passenger who leans with the operator lets the motorcycle follow its natural line, while leaning against the lean fights the operator's control inputs.

  23. 23. A small signal face beside a bikeway shows red, yellow and green lenses that each carry a bicycle symbol. Whom does it control?

    Show answer

    Answer C: Bicyclists using that crossing or bikeway

    A bicycle signal face governs bicycle movements only, and people on foot at the same corner still follow the pedestrian signal.

  24. 24. Which set of qualities should eye protection for riding have?

    Show answer

    Answer A: Shatter resistant, free of scratches, and sealed against the wind

    Riding eye protection has to survive an impact, let you see clearly and keep the air out, which is why plastic face shields and goggles are used instead of ordinary glasses.

  25. 25. You are in a minor collision on a busy road. No one is hurt and both vehicles can be driven. What is the recommended thing to do?

    Show answer

    Answer C: Move the vehicles out of the travel lanes to a safe spot before exchanging information

    Vehicles left in traffic after a minor crash invite a second, often worse, collision. Clearing the lane protects everyone, and you still exchange details and report as required.